The full length DASH roof rack has been specifically designed for the Y62 to give full functionality of the sunroof. Knowing these are big cars we have kept the height to a minimum.

Dimensions: 2.3x1.4m
Weight: 42kg (allowing 58kg loading)
Only adds 70mm to the overall height of the vehicle


In accordance to Australian Standards AS 1235-2000 - Paragraphs 6.2,6.3&6.4 DASH Offroad has the below ratings to this roof rack

Static load less than 400kg: This is for when the vehicle is not in motion and weight that can safely be added on top of the roof rack, for example, roof top tent and occupants.

On road 120kg: We have conducted destructive testing to prove that this rack can withstand 120kg of additional weight on top of the rack for on road use without causing any deformation or failure. Strongly note that the roof limit for a Nissan Patrol Y62 is 100kg and should not be exceeded. This includes the cargo AND the weight of your roof rack.

Off road 120kg: Three directional dynamic tests were conducted, as stipulated in AS 1235-2000: Cyclic Test – Dynamic factor 3 to 2,000,000, Cycles infinite life. For this roof rack, there will be no penalty of weight rating reduction when used in an off road application. Strongly note that the roof limit for a Nissan Patrol Y62 is 100kg and should not be exceeded. This includes the cargo AND the weight of your roof rack.

City crash test – Frontal impact: The Dash Offroad Roof Rack was tested for 120kg safe load capacity to ISO 11154:2006, TSF3905G and TSF3905G-1 and PASSED all the requirements prescribed by the above standards, without degradation of the system to extend that would affect safety of the vehicle occupants or other road users. 


Q. Does the roof rack come with the side rail?
A. Yes, the roof rack includes both the platform and the rails.

Q. Where are the instructions?
A. We are working as fast as possible to deliver detailed step by step instructions on many of our products however, due to Covid and border restrictions our instruction writer and supplier are stuck interstate and as such we can not write instructions in detail.
Feel free to contact us on 08 8287 4748 or sales@dashoffroad.com.au and we can assist you as best as possible

Q. How do I fit the wind deflector?
A. Using 4x slide nuts of the M6 size, you slide them into the front rail from the underside. Affix the wind deflector in such a way that the angular side is at the front of the roof rack. When looking at the front of the vehicle it should deflect air and water toward the roof (not scoop it.) You will have to use 4x m6x25mm button head screws and an alen key to tighten. 
NOTE: it is far easier to do this when not fitted to the vehicle and while the rack is upside down being assembled

Q. What are the right-angle brackets for? 
A. These are our complimentary awning mounts for an awning. They are attached using the m8x25mm button heads and slight nights on any side of the roof rack. 

Q. What are the 24 rubber washers for?
A. These are for sealing the gaps when mounting the rails to the vehicle. 
One goes on the roof, then the rail, then the other on top. A silver washer then goes on top and is tightened down with the stainless hex bolts into the roof.
NOTE: additional sealant is advised to prevent any leaks getting through to the roof liner. 

(pred07FL)

SKU pred07FL
Brand DASH OffRoad
Shipping Weight 30.0000kg
Shipping Width 0.250m
Shipping Height 0.250m
Shipping Length 1.850m
Shipping Cubic 0.115625000m3

Be The First To Review This Product!

Help other DASH OffRoad users shop smarter by writing reviews for products you have purchased.

Write a product review